HIVE-Project

ethernet is not cooperating.

When I connect either unit to my lab hub, the Link/Active light comes on at the port on the hub.

The LED on the Hive ethernet connection flashes every several seconds,
but the browser says 'can't establish connect on to 192.168.2.1:88'

I also tried windows hyperterminal with a similar result.

Behavior is the same on both units

Any suggestions?

Propforth works on Reg and Admin;
And propforth_hires_vga works on bella, after the following changes:

In Hiresvga.f, change

line 218 \ 08000000 constant kbclock
line 219 \ 04000000 constant kbdata

to

line 218 \ 00010000 constant kbclock
line 219 \ 00020000 constant kbdata

As usual, load propforthhiresvga.spin into Bella EEPROM
paste hiresvga.f into the serial terminal propgram;
execute SAVEFORTH
reboot

However Bella does not talk to the other YET and I have to get up early tomorrow.

Have you adjusted the ip-number to your network? What is the ip of your pc? You can use the "ipconfig" command in the command line.

drohne235 hat geschrieben:Have you adjusted the ip-number to your network?

That was the problem. Both units are now fully functional.

Hive 4 and Hive 60 are complete.

Thanks for all the help!

Hey, this is a fantastic news! Welcome in the hive: You now have the deserved right, you call drone004 & drohne060...