Ich messe dort -10.7V.Rainer hat geschrieben:Kannst Du mal messen wieviel Volt Du auf dem Rx - Pin hast ? (Die LED's bitte erst entfernen)
Weiss Du was wäre wenn der Quartz defekt ist?
Grüsse Joshy
Ich messe dort -10.7V.Rainer hat geschrieben:Kannst Du mal messen wieviel Volt Du auf dem Rx - Pin hast ? (Die LED's bitte erst entfernen)
In der Boot-Up Prozedur wird folgendes vermerkt:4.2. System Clock
The System Clock (shown as “CLOCK” in Figure 1, page
1) is the central clock source for nearly every component
of the Propeller chip. The System Clock’s signal comes
from one of three possible sources:
• The internal RC oscillator (~12 MHz or ~20 kHz)
• The XI input pin (either functioning as a highimpedance
input or a crystal oscillator in
conjunction with the XO pin)
• The Clock PLL (phase-locked loop) fed by the XI
input
The source is determined by the CLK register’s settings,
which is selectable at compile time and reselectable at run
time. The Hub and internal Bus operate at half the
System Clock speed
Was mir nicht klar ist: Läuft mit internem Oszillator auch auch der Hostdialog? Das kann ich morgen testen wenn ich einen Propeller in den Prototypen 1 stecke - dieser hat gesteckte Quarze, wodurch ich einen deaktivieren kann um das zu testen.1. The Propeller chip’s internal RC oscillator begins
running at 20 kHz, then after a 50 ms reset delay,
switches to 12 MHz. Then the first processor (Cog 0)
loads and runs the built-in Boot Loader program.